Super Penetration Primer

DESCRIPTION
A highly penetrative, thin bituminous solution, black in colour.

USES
Use Super Penetration Primer for priming surfaces prior to the application of bituminous materials.

Super Penetration Primer can be used to prime concrete roofs and floors,
cementitious screeds/renders, bitumen felt, weathered bitumen, mastic asphalt, weathered corrugated iron and steel. It is the recommended primer for use with the Aquamac range of bituminous roof coatings and with ATA flooring adhesive for thermoplastic vinyl tiles.

PREPARATION
Ensure the surface is structurally sound, clean and dry. If necessary remove any surface contaminants such as grease, moss, lichen or any other organic growth with Fungicidal
Wash.

APPLICATION
Apply by brush or spray. Using a brush, scrub the primer into the surface. Ensure that only a thin coat is applied and that there is no pooling. Alternatively spray thinly and evenly. Allow to dry thoroughly before over coating.

With fibre cement or dry rag based bituminous felts, apply generously to saturate the surface

SAFE HANDLING PRECAUTIONS
Flammability: Flammable
Keep away from sources of ignition including pilot lights and sparks (see Note). Take precautionary measures against static discharge. Keep containers tightly closed when not in use.DO NOT SMOKE.

If used in an enclosed space ensure thorough ventilation of the area (using flame proof mechanical blowers if necessary) to avoid any accumulation of vapour until the product has dried. In case of fire use dry powder, carbon dioxide (CO2), foam, sand or earth. Never use water as this may spread the fire.

Note: Electric motors, light/power switches and steel tools may generate sparks
sufficient to ignite the product or its vapour, resulting in an explosion and/or fire.

Skin Contact: Contains solvents that cause de-fatting of the skin and, in extreme circumstances dermatitis. Avoid contact by careful working and use of
barrier cream on hands, arms and other exposed areas or wear gloves. Remove
skin contamination immediately with a proprietary hand cleaner and wash with
soap and water.

Eye Contact: Avoid contact. Could have an irritating effect. In the event of accidental contact, wash eyes immediately with clean water for 15 minutes and obtain medical attention.

Inhalation: Contains low volatility solvent. When used on roofs stand upwind of the work and avoid inhalation. Switch off all working ventilation inlets prior to using the material; leave covered until there is no odour of the solvent in the vicinity. Indoors, use only in well
ventilated areas. In the event of discomfort as a result of inhalation move person to
fresh air. If discomfort persists obtain medical attention.

Oral ingestion: With proper handling this should not occur. The possibility can be minimised by not consuming food in the working area and by washing hands
thoroughly before eating, drinking or smoking.

Spillage: Spilt material should be mopped up immediately with an inert absorbent material, such as sand, and disposed of in accordance with regulations.

Disposal of Containers: Do not leave containers on site where residue could be a hazard to children, animals or the environment. Replace lids securely and
remove any containers to a central disposal point.

Cleaning of Tools: Clean with paraffin (kerosene) or white spirit.

Storage: 12 months under good storage conditions in original unopened containers.

Storage Conditions: Containers must be kept sealed and stored under cover away
from sources of heat and ignition.